KJT now have three production lines in factory and are preparing to install the next two new lines in the coming months. KJT engineering department has the capability to design new sensors and support existing products with technical advice and application changes.
KJT's zero speed Hall effect sensors for measurement of hub speed and shaft revolutions, etc are en¬ Gineered with an internal magnet to switch in the presence of ferrous targets such as gear teeth and blade tips down to absolute zero speed. The sensor detects fluctuations in the magnetic field and can also be configured so the output signal signifies either the presence or absence of a ferromagnetic target(i. e. A gear tooth, shaft feature, etc).
SPECIFICATIONS SUPPLY VOLTAGE Vs: 8-30 VDC @ 15mA MAX. Reserve Polarity Protected PULSE OUT Vo: Push-pull outputs: Imax = +/- 20 mA, Ulow < 2.5 V, Uhigh > Usupply-3.5 V OPERATING FREQUENCY: 0-20kHz AIR GAP MODUL E 0.5: 0.1 to 0.3mm MODULE 1: 0.1 to 1.5mm MODULE 2: 0.1 to 2.0mm VIBRATION/SHOCK RESISTANCE: 5 G's @ 2000 Hz MIN.; IMPACT: 50 G'S MIN INGRESS PROTECTION Sensor head: IP68 Cable outlet or connector: IP67 TEMPERATURE RANGE: -40 Celsius degree to 125 Celsius degree CONSTRUCTION: Stainless Steel or Plastic Housing, Sold Epoxy Encapsulation
Advantage Speed detection from Zero speed to 20kHz Digital output Extremely accurate No special alignment requirement relative to the pole wheel or target gear Large air gap High temperature range (-40 Celsius degree to 125 Celsius degree) 2-year warranty Low cost
当前位置：
产品详细介绍